
There is a cart stop on the front of it that sometimes wears down and when that happen you will get double feeds. This is the part that comes out the bottom when you work the lever to open the action. The biggest issue with the late production Model 94AE is the fact that they have a tang safety (an ugly departure from the original design. Repeating Arms Company shutdown the New Haven factory for good). But, the first thing I would look at is the lever-link. Your Model 94AE was manufactured sometime after the year 2002, and before March of 2006 (when the U.S. Without the gun in hand it will be hard to say. Even shoot one of 'em in long range competition. It may require the same welding and filing (fitting) as one you'd get from Numrich. Let me check my spares, I may even have an extra link. Any link from any year 94 or 94AE will work, just depends on your receiver for it's retention. Depending upon the year your rifle was made, (AE or top eject), you'll need either a screw (same screw as the hammer, btw), or a pin and set screw. :grinpimp: I cannot get the spring compressed into the assembly. I SHOULD have taken a picture before I took it apart. 30-06 were all derived from the.30-03 parent case and the bore diameter was Winchester 94ae wrangler - Winchester 94ae wrangler Winchester 101 parts diagram Winchester 101 parts diagram. I thought I would remove the safety that cost me several deer when I was a teenager from my trusty Winchester Ranger Model 94 angle eject 30-30. check with Numrich and see if they happen to have a link out of a. 280 Remington, both of which are longer than the.
#Disassemble winchester 94ae 30 30 serial number#
When you put the bolt back in it will want to stop when it gets to the hammer. What is the value of a Winchester model 94ae 30-30 serial number 6502494 Your Winchester model 1894 angle eject rifle will bring between 250-350 dollars,depending on the overall condition of the rifle and a good bore.

now) decided to disassemble one of my Sears Ted Williams Model 100 s (Winchester 94) from.

It will still be visible in the tube and about 1/4' up in there. Thread: Info on Sears and Roebuck Ted Williams 94 Winchester. If you do not see it, it is either missing or the spring that tensions it is. You will need to push it back from the front of the bolt tube until you feel it set on the sear. If you open the breech and look down at the bolt face, the ejector is the little rectangular bit that sticks out past the bolt face at the 6:00 position. The ejector on a post-'64 is pinned to the bottom of the bolt. When removed, weld up the tip up and then file to stop the cartridge as the link drops out of the receiver, but allows a cartridge to feed onto the carrier when the lever lowers the carrier and the link rises back into the receiver. Re: Winchester Model 94 30-30 Extraction Issue. The cartridge stop on the front of the link is worn.
